Maui Forums
1703 fails to read partitions (I think) during install [solved] - Printable Version

+- Maui Forums (https://forums.mauilinux.org)
+-- Forum: Maui Support (https://forums.mauilinux.org/forumdisplay.php?fid=74)
+--- Forum: Installation (https://forums.mauilinux.org/forumdisplay.php?fid=83)
+--- Thread: 1703 fails to read partitions (I think) during install [solved] (/showthread.php?tid=24477)



1703 fails to read partitions (I think) during install [solved] - markce - 27th May 2017

I have a desktop (AMD FX-8320) with Maui 2.1 OS.  I tried to do a clean install of Maui 1703 which starts fine off a usb. The installation however stalls at "Gathering system information".  I tried KDE Partition (v3.0.1) from the usb iso and it also fails at reading the hard drives.

KDE Partition v3.0.1 on the installed Maui 2 successfully reads my drives. The usb iso also successfully installed 1703 on an older HP laptop so the image is not a problem.

I couldn't find a similar issue in the forums, so ... any suggestions?

The computer has developed an intermittent and irritating slow down over the last several weeks and I have no idea if this is software or hardware (subject of another post). It was because of this problem that I was trying Maui1703 as a test. Just mentioning in case there is a connection.

Thanks


RE: 1703 fails to read partitions (I think) during installation - leszek - 27th May 2017

Are the devices listed when running live under /dev? (For example /dev/sda1)?
If yes perform a filesystemcheck on that devices from the live system.

Also you can try installing gaprted and try if it is able to detect the partitions.


RE: 1703 fails to read partitions (I think) during install [solved]ation - markce - 1st June 2017

Thank you leszek

Yep, after a system check and correction of disk errors in one partition, installation proceeded.